$15.00
Compression piston rings are essential parts of an automobile engine. The rings are produced by four-roll bending using high-tensile steel alloy. However, defective phenomena of the distortion and the gap, etc., occasionally occur. This research aims to improve the compression ring with more accurate dimensions by using FEM analysis and experimentation. It was found that these defects were reduced through arrangement of the roll and intermesh.
Compression piston rings are essential parts of an automobile engine. The rings are produced by four-roll bending using high-tensile steel alloy. However, defective phenomena of the distortion and the gap, etc., occasionally occur. This research aims to improve the compression ring with more accurate dimensions by using FEM analysis and experimentation. It was found that these defects were reduced through arrangement of the roll and intermesh.
| Author(s) | Yuma Watanabe, Motoo Asakawa, and Hiroshi Iwanaga, Waseda University, Japan |
|---|---|
| Publication/Event/Pages | Paper presented at WAI's 83rd Annual Convention (Interwire) in Atlanta, April 2013. |
| Year | 2013 |
The Wire Association International, Inc., 71 Bradley Road, Suite 9, Madison, CT 06443-2662
Phone: (203) 453-2777
The Wire Association International (WAI), Inc., founded in 1930, is a worldwide technical society for wire and cable industry professionals. Based in Madison, Connecticut, USA, WAI collects and shares technical, manufacturing, and general business information to the ferrous, nonferrous, electrical, fiber optic, and fastener segments of the wire and cable industry.
Copyright © 2025 The Wire Association International, Inc. All Rights Reserved
